20130403 писал(а):
Возможно, Вы не знаете, что такое поляризатор. Как-то неуверенно Вы написали об этом. Тем более, что если вбить в поиск ICR, то сразу становится ясно что это. Вы на микроскопе какую работу проделываете?
ICR На этих деталях просто указывает направление ориентации призмы относительно анализатора/поляризатора. Это не призмы.
Код:
This is a polarizer slider for the Leitz (Leica) Ergoplan semiconductor microscope it may fit other instruments as well. The Leitz part number is 573 097. The dimensions of the slider are 120mm in length, 28.5mm wide, and 11.5mm deep. There is a small bevel on the upper forward edge of the slide to prevent accidental insertion of the slide in the inverted position.
The slider consists of three elements. The first is the actual polarizing filter. Then there is a plate inserted in a cutout that appears to be a quarter-wave plate that is oriented so the permitted vibration directions are parallel to the analyzer and polarizer in other words, no light is passed in that position. Then there is a third element opposite the polarizer. Behavior of the slider was similar whether it was upright or inverted when an analyzer was placed in front of the slider and brought to the extinction position (no light transmission) and the slide was inverted, there continued to be zero transmission. The central plate also has a pair of set screws so it can be critically set.
I have been unable to figure out the function of these additional two plates. There was an earlier version of the Leitz reflected light interference contrast in which the polarizer could be rotated behind a fixed quarter-wave plate this permitted a variation in the contrast without having to move the Wollaston prisms with respect to the optic axis, instead the polarizer is rotated behind the fixed quarter-wave plate. However, in the Ergoplan, the polarizer is fixed and the Wollastons are adjustable.
Т.е. Если в ЛОМО или в Nikon призмы подвижны и их смещением можно контролировать порядок интерференции, то в данном случае эту роль выполняет 1/4 волновая пластинка, вращаемая в плоскости, по типу компенсатора Сенармонта.
Призмы должны быть при объективах, по идее, сами объективы высотой 31мм, 14мм - призма с указанием объектива. Однако это переходный микроскоп, в момент поглощения Reichert Leitz'ом, поэтому там может быть какая-нибудь хитрая схема, управляемая моторами с контроллера, надо турель снять покрупнее и с нескольких ракурсов.